Construction Heat Application

The following guidelines for construction heat have been developed from current local codes. Questions regarding these guidelines should be directed to the New Services Department at 317-927-4444.
 
Guidelines For Construction Heat

1. All piping systems must be in accordance with all applicable state and local codes and follow acceptable pipe installation practices
2. Gas hose must be protected from damage and at least 10’ long, but no longer than 25’
3. Flexible gas hose shall be provided with gas shut off valves in readily accessible locations in rigid piping systems upstream from the flexible hose
4. At the appliance connection, the connection must be made as follows: valve, nipple, union, the appliance
5. At least one temporary construction heater that is listed or approved must be installed prior to service being initiated
6. Any regulator used for construction heat shall be vented to open atmosphere, if not designed by the manufacturer to be used with an approved leak limiting device

Site Information

---

Service Address:
Property Type:  Residential/Multi-family Commercial Industrial
Service City:		Service State:
Site Contact First Name:		Site Contact Last Name:
Site Contact Email:		Site Contact Phone Number:

Customer Billing Information

---

Customer (party to be invoiced for gas use):
Billing Address:
City:		State:
Billing Contact First Name:		Billing Contact Last Name:
Billing Contact Email:		Billing Contact Phone Number:
Billing Tax ID:
Date Requested (for meter activation): Calendar

Equipment Information

---

Equipment #1:		Total Units:		BTU Input/unit:
Equipment #2:		Total Units:		BTU Input/unit:
Equipment #3:		Total Units:		BTU Input/unit:
Equipment #4:		Total Units:		BTU Input/unit:
Equipment #5:		Total Units:		BTU Input/unit:
Equipment #6:		Total Units:		BTU Input/unit:
Equipment #7:		Total Units:		BTU Input/unit:
Equipment #8:		Total Units:		BTU Input/unit:
Equipment #9:		Total Units:		BTU Input/unit:
Equipment #10:		Total Units:		BTU Input/unit:

 

Delivery Pressure: 6” Water Column (1/4) PSIG 2 PSIG 5 PSIG Line Pressure
Notes:

Terms and Conditions

---

I agree to the Terms and Conditions and I have been authorized by the property owner to perform the work described in this application. By checking this box, I acknowledge that I have read the above information and will ensure onsite compliance to these temporary construction heat guidelines. Responsibility to these guidelines are enforceable as long as temporary heating is used.

By clicking the submit button below, the applicant agrees to comply at all times with Terms and Conditions for natural gas and all other applicable rules, regulations, and standards (local, city, state and federal).

Once your submission is reviewed, a representative will contact you for the next steps with your application including any additional information that may be needed.